Knowledge

Is Triethylene Glycol (TEG) Safe? Uses and Safety Guide

Nov 17, 2025 Leave a message

What Is Triethylene Glycol (TEG)?

Triethylene glycol (TEG, CAS 112-27-6, molecular formula C6H14O4) is a colorless, odorless, hygroscopic liquid belonging to the glycol family. It is produced by the condensation of ethylene oxide with glycols and is completely miscible with water and most organic solvents. With a high boiling point and low volatility, TEG is valued as a dehydration agent, plasticizer, humectant and solvent across many industries.

Is TEG Safe for Skin?

Triethylene glycol has a very low acute toxicity (oral LD50 in rats is about 17,000 mg/kg) and is not classified as hazardous to health under most GHS-based regulations. Occasional skin contact is generally well tolerated, although sensitive individuals may experience mild, transient irritation. TEG is not a typical ingredient in modern cosmetic and skincare products, so routine consumer skin exposure is low.

In industrial environments, however, chemical-resistant gloves, safety goggles and protective clothing are still recommended because repeated or prolonged contact, contaminated product, or splashes into the eyes can cause irritation. If skin contact occurs, wash thoroughly with soap and water; if the product enters the eyes, rinse with clean water for at least 15 minutes and seek medical advice.

Key Properties

Property Value
CAS number 112-27-6
Molecular formula C6H14O4
Molecular weight 150.17 g/mol
Appearance Colorless, viscous liquid
Boiling point 285 - 295 C (approx. 288 C)
Flash point 165 - 177 C (closed cup)
Density (20 C) 1.122 - 1.126 g/cm3
Water solubility Miscible

Main Industrial Uses

Natural gas dehydration: TEG is the standard absorbent in glycol dehydration units that remove water vapor from natural gas streams.

Plasticizers: used in cellulosic and polyester (PBT) film formulations to improve flexibility.

Solvents: dissolves nitrocellulose, resins and dyes in inks, coatings and cleaning formulations.

Lubricants and hydraulic fluids: water-soluble lubricants and coupling fluids.

Humectants: retains moisture in textile, leather and tobacco processing.

Chemical intermediates: polyester polyols, polyurethane and unsaturated polyester resins.

Packaging

TEG is typically supplied in the following packages.

Package Quantity / 20 FCL
160 kg drum 12.8 MT
800 kg IBC drum 16 MT
ISO tank 18.5 MT

Frequently Asked Questions

Q: Is triethylene glycol safe for skin?
Yes, TEG has low acute toxicity and causes only mild irritation in sensitive individuals; standard industrial PPE is still recommended for handling.

Q: What is the CAS number of triethylene glycol?
TEG has CAS number 112-27-6 and molecular formula C6H14O4 with a molecular weight of 150.17 g/mol.

Q: What is the boiling point of TEG?
TEG boils at about 285-295 C (approximately 288 C) and has a flash point of 165-177 C closed cup; its low volatility is why it is not classified as a flammable liquid in most regulations.

Q: How is TEG used to dehydrate natural gas?
In glycol dehydration units, wet natural gas is contacted with TEG in an absorber, where the glycol absorbs water vapor; the water-rich glycol is then heated in a regenerator to strip out the water and is recycled, allowing the gas to reach very low water dew points.

Q: What packaging is available for TEG?
TEG is typically supplied in 160 kg drums (about 12.8 MT per 20-foot container), 800 kg IBC drums (about 16 MT per container) and ISO tanks (about 18.5 MT).

Q: What is the acute toxicity of TEG?
TEG has very low acute toxicity, with an oral LD50 in rats of about 17,000 mg/kg, and it is not classified as hazardous to health under most GHS-based regulations, although eye contact and repeated or prolonged skin contact should still be avoided.

Send Inquiry